Author:

ZHAOSHI

Time:

Apr 17,2026

Typical workpieces: fan-guard rings, dust-removal skeletons, furniture racks, clamps, 3D stainless brackets and carbon-steel springs. Send a drawing or sample for a trial run.

1 / 2

Automotive

2 photos

Automotive Clip Wire Form

High-repeatability automotive clip sample from servo wire bending cell.

This automotive clip wire form is a representative sample produced on Zhaoshi servo wire bending cells. The part is formed from spring steel wire in a single continuous cycle: straightening, feed, bend, and cut-off, with no secondary manual bending operations.

Application context: retaining and fastening clips for automotive assemblies, where bend geometry and leg spacing must repeat across high-volume lots.

Servo-controlled bend axes allow the clip’s multiple bend planes to be programmed and reproduced without tooling changeover between runs.
Wire is fed from coil through a straightener unit ahead of the bending head, keeping pitch and leg length consistent.

For buyers evaluating equipment, the relevant question is not the sample itself but whether the cell holds the clip’s tolerances at production rate. Request a drawing review with wire diameter, material grade, and bend sequence so the machine configuration can be matched to the part rather than the part adapted to a fixed tool set.

Get a Quote Back to gallery

none